Sale

3" 3/4 HP TH3-006-20 230V 1Ph. Complete Set incl motor, pump-end and control box

Tuhorse
SKU:
TH300620M230
US$659.00 US$369.00
(2 reviews)
Weight:
31.00 LBS
Width:
40.00 (in)
Height:
10.00 (in)
Depth:
8.00 (in)
Condition:
New
Current Stock:
Maximum Purchase:
3 units
Adding to cart… The item has been added

Complete submersible deep well pump end, motor, and dual capacitor Control Box Pro set. Complete Instructions.

If you have a hard time pulling your old 4 inch pump off the well because the 4" steel well casing is rusted or the PVC casing is melted, consider to use a 3" pump instead.

This 6GPM pump is made for a low yield deep well. It is suitable for a small family without a sprinkler system. 

Model: TH3-006-20

  • Fit 3-1/4 inch and larger ID well
  • HP: 3/4HP
  • Voltage: 230V Single Phase
  • Cycle: 60 Hz
  • Operating Amperage: 4.5 A
  • Motor RPM: 3450 RPM
  • Stages: 20
  • Maximum Head(cut off): 400 ft
  • Rated Flow: 6 GPM
  • Maximum Flow (0-120 feet): 8.5 GPM
  • Open Flow vs Depth: 8GPM @ 190ft; 7GPM @ 250ft; 6GPM @ 310ft; 5GPM @ 350ft
  • Suction Port: Center Suction
  • Discharge Port: 1 inch NPT
  • Built-in Check-valve: Yes, but an external check valve is required in water tight system
  • Housing Material: Stainless Steel 304
  • Discharge and Suction Port Material:  Stainless Steel 304
  • Impeller Material: Thermal Plastic
  • Motor Enclosure: Stainless steel 304
  • Motor Bearing / Lubrication: Ball bearing, oil filled
  • Motor lead: 4 wires (3 wire + 1 ground)
  • Duty: Continuous or up to 30 restarting cycles / hour
  • Control Box: Dual capacitor control box included
  • Weight: 20 lbs
  • Assembled Dimensions: 39.5" long x 2.87" diameter
  • Packing weight with control box: 30lbs
  • Packing Dimensions/Length: 40"x26"x10 (101cmx26cmx18cm 

 

1 Year

Reviews

  • 5
    Very good pumps

    Posted by Alexis Ortiz on 21st Jul 2022

    This pump is very good, is better than grunfos, excellent products , good presion, friendly foe use and not is expensive. Recommend 100%.

  • 4
    Good Pump

    Posted by Justin B on 24th May 2021

    Seems to work well. I have it set at 240 foot depth, when the well is idle for several days the static will rise to about 180' (60' below the surface) Pump will start out at about 8.8 GPM, minimum flow is 6.6 GPM when the head drops down to pump level. The only surprise I had was that this pump shipped out of Canada, therefore my credit card was charged a foreign transaction fee.